Description
Specification
PRODUCT NAME : | Smart LED RGBCW strip |
MODEL NO. | NXIORGBCW-3.6WM |
SPECIFICATION • | DC12V,18W |
WORKING TEMP : | -20-50(C) |
CRI(RA) : | >80 |
BODY COLOR : | White |
LIGHT SOURCE : | SMD 5050 RGB,300 Chips |
LIFE TIME : | 30000 hrs |
BEAM ANGLE : | 120 degrees |
PRODUCT SIZE : | 5000*10mm, 5meter/Roll |
CUTTING LENGTH: | 50 mm
IP65 |
APPLICATION : | Home, Shop, Hotel |
WARRANTY • | 2 years |
STANDARD : | FCC |
COLOR TEMP : | RGBCW+16 Million colors |
ENABLED : | Wifi+Bluetooth |
DIMMABLE • | YES |
SPECIFICATION
Installation:
(j) Choose a dry, clean and smooth | @ Strip off the protective film. | @ Stick the strip light and press over | @ For corner setup, bend the strip | |||||
surface. | (Notice: Do not peel off the tape | it about 10-15s. | and reinforce via clips. | |||||
(Notice: Do not stick the led strip on | under the film.) | (Notice: Avoid bending on LED | ||||||
the surface, such as knitted / wool fabrics, dust wall, rough plastic surface, frosted glass. ) | beads.) | |||||||
|
||||||||
($) Connect the arrow of controller | @ Connect the controller to the DC | @ Installation completed. | ||||||
to the arrow of LED Strip Lights. | wire. | Use the IR remoteto turn on and operate the lights. | ||||||
Warning
ODO not connect to the power supply before installation.
@Please spread out the light strip before connecting the power supply.
For Full Color light strips only | 7
6 |
I.On/Off: Press to turn the light on/off. |
2.Adjust Brightness: Dim or brighten the light. | ||
3.Color Selecting: Press to change the color.
R: Red, G: Green,B: Blue, W: White |
||
4.Colorful Mode: Press to change the colorful scene mode. | ||
5.Speed: For scene mode, press it to speed up or slow down the changing of lights; For music mode, press it to increase or decrease the sensitivity of the mic. | ||
6.Rainbow Mode: Press to cycle through Four rainbow scene modes. | ||
7.Music Mode: Press to cycle through Four music modes. |
NOTICE:
1 . Please pull out the transparent chip from the bottom of the IR remote to ensure that the battery is powered properly.
2.Make sure the IR remote aims at the controller within the sensing distance. The angle of the controller is 120 0 and the sensing distance is 3 meters. Please remotely control within the sensing range.NX10RGBCW-3.6WM-Specification
Reviews
There are no reviews yet.